It is an ideal and fast way of installing draw ropes and winch ropes into ducts ready for cable pulling operations
we offer a wide variety of accessories for cable laying & Duct rod .
Duct Rod and Accessories
It is an ideal and fast way of installing draw ropes and winch ropes into ducts ready for cable pulling operations
| PRODUCT CODE | DESCRIPTION |
|---|---|
| DU 0075 A | Duct Rod 4.5mmX50m(L) |
| DU 0076 A | Duct Rod 4.5mmX80m(L) |
| DU 0052 A | Duct Rod 6mmX50m(L) |
| DU 0052 B | Duct Rod 6mmX100m(L) |
It is an ideal and fast way of installing draw ropes and winch ropes into ducts ready for cable pulling operations
| PRODUCT CODE | DESCRIPTION |
|---|---|
| DU 0053 A | Duct Rod 9mmX100m(L) |
| DU 0066 A | Duct Rod 9mmX200m(L) |
| DU 0004 A | Duct Rod 11mmX150m(L) |
| DU 0005 C | Duct Rod 11mmX300m(L) |
| DU 0054 B | Duct Rod 14mmX300m(L) |
| DU 0056 A | Duct Rod 14mmX500m(L) |
Heavy Duty Duct Mandrel with pulling eyes on each
end for removing obstructions from the duct. Body
made of Mild Steel
Finish : Hot Dip Galvanized
Duct Mandrel with pulling eyes on each end for
removing obstructions from the duct. Body made of
Nylon. Ball Mandrels to be used at the ends
Plastic bristles with a pulling eye on each end. Easily
removes sand, grit and other light obstructions from
the duct.
Heavy Duty Wire Brush Mandrel with pulling eyes on
each end for removing obstructions from the duct
A slow drying wax based lubricant with superior
friction reducing properties. This is especially
recommended for long pulls, high shear situations,
and multiple bend pulls. It leaves a lubricating film
after its water has evaporated.
Operation Output Pressure 700kg/cm². 1.8m high
pressure oil tube, with fast connection point
Model No : TP-630H
Crimping Range 16mm²-630mm² used with Hydraulic
hand and foot operated Pump
Model No : S-120H
It is designed to cut Copper cables unarmoured and
armoured having a max overall diameter of 120mm
Used with Hydraulic Hand and Foot Operated Pump
Used for Cable Laying applications within Ducts above
or below the ground. The rod is fitted with a quick
release spring loaded Brass ‘Ferret’ mechanism to
lock the thread and give good joint security
Fits into tapered head to provide a larger pulling loop
for attaching the rope or pull line
Screws onto the threaded end, fitting to allow for
easy wire attachment when pulling wire into conduit
Helps guide the duct rod around bends, sweeps and
duct misalignments
Connects two duct rods pushed intp the conduit from
the same end. Used when one length of duct rod is not
enough for the full conduit run. Also used as a rotating
swivel, when pulling wire or rope with the tapered head.
Helps guide the duct rod around bends, sweeps and
duct misalignments. Also used when the conduit is
already occupied by other cables
Gets attached to the end, fitting on the duct rod
Guides the duct rod through the conduit and allows a
pull line (diameter A) to be attached to the duct rod